The 2-Minute Rule for roof waterproofing
The 2-Minute Rule for roof waterproofing
Blog Article
• When you have various containers of SEMCO Liquid Membrane™, we very advise to both blend them jointly or use just one container for the final layer to receive shade consistency.
• a bit dampen the area with drinking water. this may avert cleaners to penetrate deep into the pores on the substrate
• It cannot be placed on damp substrates or substrates continue to that contains dampness, else it won't treatment accurately and continue to be tacky. Max. relaxation humidity in substrate could be nearly three%. If you're Not sure about the moisture articles, have it measured prior to software.
often the exact same materials accustomed to preserve drinking water from structures are accustomed to hold drinking water in, like a pool or pond liners.
if you want help with which cleaners are wanted to the Prep, Be happy to make use of our Dwell chat or connect with us!
3 Masking Mask off parts that aren't receiving any coating. clear away masking tape just before materials has totally cured.
3 Masking Mask off locations that aren't obtaining any coating. Remove masking tape ahead of substance has completely cured.
• treatment times are shown within our curing chart. However if coats are used way too thick, the area could feel tacky.
contrary to other kinds of roofing components, waterproof membranes have an Nearly indefinite lifespan — though They might want substitution just after twenty five yrs or so according to variables like exposure to sunlight and environmental ailments for instance wind and rain.
Ensure your surfaces are thoroughly cleaned and dried. In case you have any rust with your surface area, make use of a h2o centered rust primer to start with.
Use a 1/2" nap roller. enable any pre-treated parts to fully dry. Apply a skinny coat (0.015 inch for each coat) of SEMCO Liquid Membrane™ with brush or roller over substrate which includes pre-treated parts. Once you can wander within the floor rather than get any residue on your shoe or feet or simply cannot leave a fingerprint impression it is ready to re-coat. Apply A further skinny coat of SEMCO Liquid Membrane™ within an alternate route about the main coat of SEMCO Liquid Membrane™.
• For best bonding we really suggest making ready the area as pointed out over for greatest outcomes.
protection may perhaps range based on porosity on the substrate. For corrugated steel please estimate no less than 33% more content.
very best is to here empty the pool/fountain or pond and permit curing to happen. doubtful get to out to customer support by way of call, e-mail or Stay chat.
Report this page